Crystal reports v9 parameter problems

[KeyNoteSteve]

I have a V9 Crystal report with 2 parameters. It runs fine when I run the report 'directly', however, when I use the same report as a subreport, I cannot pass the two parameters to the subreport -- it comes up blank wihtout an error. 1 parameter works fine, but 2 is a problem.

Any ideas?

[henky@nok.co.id]

Did you link the subreport?
If you did, do the parameters between report and subreport have same
type of data?

[KeyNoteSteve]

The report is not linked -- its imported. I will double check next week (I'm on vacation this week) but am pretty sure var types are matched.