Cannot link from strored procedure...Error detected by DLL

[dubasi]

Hi,

I'm using Crystal Reports Version 8.5 and SQLServer2000.
The main report is using Stored Procedure as datasource where as 2 sub reports using tables as datasource. I'm linking these subreports with some values from the main report.

When I run the main report it pops up the two error messages saying that

"Cannot link from strored procedure" followed by "Error detected by DLL".

Pls advice. Thanks in advance for your immediate attention.

[Madhi]

Is that Stored Procedure exits?
If not redesign the report

[dubasi]

Hi Madhi,

Yes, the stored procedure exists and works fine if i remove the sub reports. So I re-designed one of the sub-reports and its working now with out any problems.

Thanks for your reply.

Dubasi